I'm running the img-version of nas4free from a harddrive.
Nas4free creates two ram disks sized resp. 196M and 32M.
This makes sense when running from CF/SD/USBkey, but it doesn't when running from harddrive.
Could we make creating a ram disks into a configurable option?
Like a checkbox "create ram disk"; checked by default to protect CF/SD/USBkey
FWIW: I tried to simply umount the ram disks, but it failes on FS BUSY
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
disable RAMdisk(s)
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: disable RAMdisk(s)
If You use Hard Disk, use full install, and You avoid RAM Disk.
RAM Disk is needed in the enbeded version (.img) to load kernel and minimizes writes on CF.
RAM Disk is needed in the enbeded version (.img) to load kernel and minimizes writes on CF.
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510