[BUG] not all disks shown in Tools page

[nicolap8]

Hi all,
on NAS4Free 10.2.0.2.1814 I386
this is my pool:

pool: zpl
state: ONLINE
scan: none requested
config:

NAME STATE READ WRITE CKSUM
zpl ONLINE 0 0 0
raidz2-0 ONLINE 0 0 0
diskid/DISK-JK2171B9HYWX4L ONLINE 0 0 0
da2 ONLINE 0 0 0
da3 ONLINE 0 0 0
da4 ONLINE 0 0 0
da5 ONLINE 0 0 0

errors: No known data errors

But when I try to do some command in the Tools page one disk is missing:

Command
Option
Pool
Devices
da2 (1907338MB, Hitachi Deskstar 7K2000)
da3 (1907338MB, Hitachi Deskstar 7K2000)
da4 (1907338MB, Hitachi Deskstar 7K2000)
da5 (1907338MB, Hitachi Deskstar 7K2000)

The disk is attached to a Sil controller:

ada1 Hitachi HDS722020ALA330 Hitachi Deskstar 7K2000 1907730MB JK2171B9HYWX4L 7200 rpm 3.0 Gb/s Available , Enabled siisch1 SIIS channel 46 °C ONLINE

Thanks
N

[b0ssman]

ddi you sync your disks on the zfs page?

[nicolap8]

ddi you sync your disks on the zfs page?

Yes. The pool was working.
I just updated Nas4Free from a very old version, reconfiguring all by hand.

[b0ssman]

then its because it cant map the diskid/DISK-JK2171B9HYWX4L

[nicolap8]

then its because it cant map the diskid/DISK-JK2171B9HYWX4L

"it"???
I think that there is an error (bug) somewhere... the disk and the pool are working.

[daoyama]

then its because it cant map the diskid/DISK-JK2171B9HYWX4L

"it"???
I think that there is an error (bug) somewhere... the disk and the pool are working.

At this time, disk ID is not supported by NAS4Free (WebGUI).