This is an old revision of the document!
The following additional Network configurations are not mandatory for the operation of NAS4Free, but may be required in some network configurations.
To configure advanced interface properties, go to the Network LAN Management page:
On this page you can configure IP addressing type: DHCP or static. Note: In both situations(Static or DHCP) you must set the DNS manually.
MTU size: Useful for enabling Jumbo frame support (if your NIC support it). You can check if your NIC card supports jumbo frame from this web site (FreeBSD manpage): http://www.freebsd.org/cgi/man.cgi Just enter your interface name (go on the Interface: Assign page for display the name of your card: fxp for example).
In addition to the LAN interface, additional Ethernet Interfaces can be defined, if required. This can be either wired Ethernet interface or Wireless interfaces. See section 5.2.3 for more information relating to wireless LAN interfaces.
The additional interfaces may be used to administer NAS4Free or to access the shares, so it can be a useful redundant interface to NAS4Free for either function.
The additional Ethernet Interface can be within the existing LAN subnet or on a completely different subnet depending on your networks configuration. Where the additional interface is on a different subnet to that of the LAN interface, additional static routes may be required to facilitate connections to the other subnet, for example, the other subnet’s gateway and beyond.
Before adding an additional Ethernet Interface to NAS4Free, ensure that the additional interfaces are installed when NAS4Free is booted.
To add an additional interface, go to the Interfaces (assign) page. If your additional Ethernet interface is recognised, you will have a alongside the standard display, as shown below. If you do not have a on this display, your interface is either not correctly installed or not recognised by NAS4Free.
OPT1 is the default name of the interface, and this can be customized. Once OPT1 is configured you will notice an additional level under Interfaces (assign) called OPT1.
Click Save and reboot NAS4Free to ensure the additional interface is recognised. You can reboot NAS4Free via the Diagnostics/Reboot System page.
Once NAS4Free is again operational, you can configure the OPT1 interface and rename it to something more relevant to your network.
As per the display shown below, Click the Enable Optional 1 interface check box.
A reboot is not required.
Security Note on additional interfaces: NAS4Free does not provide any routing between Ethernet interfaces, so any potential security risks of ‘joining’ two networks via NAS4Free should be limited. But, there is always the potential for virus infected files stored on NAS4Free to be accessible from either network, and so, it is important that a current and up to date anti-virus application is able to scan all files stored on NAS4Free, from time to time. Is not a case of viruses ‘jumping’ from one network to another, its more likely that a user on one network will save a file on NAS4Free and then that is access by another user on the other network.
In most LAN environments, a single LAN interface will be used (the LAN interface) and its default gateway will provide the interface to other networks. Where multiple LAN interfaces are configured in NAS4Free, then additional static routes may be needed in FreeNAS to permit network traffic to the other networks. Note: This configuration is usually not required unless you have to direct traffic from one subnet via another.
In the example below the interface ‘LAN’ has the IP Address of 192.168.80.130 and its default gateway is 192.168.80.254, my Internet router. I have another router with a local address of 192.168.80.2 that is connect to another network (10.1.1.0/24). In order for FreeNAS to direct traffic to the 10.1.1.0/24 network, a static route is configured directing any 10.1.1.0/24 traffic to the 192.168.80.2 (local router to its remote network) via the LAN NIC.