User Tools

Site Tools


documentation:setup_and_user_guide:network_interface_lan

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
documentation:setup_and_user_guide:network_interface_lan [2018/09/30 22:52]
zoon01
documentation:setup_and_user_guide:network_interface_lan [2018/09/30 22:53] (current)
zoon01
Line 29: Line 29:
 Before adding an additional Ethernet Interface to XigmaNAS, ensure that the additional interfaces are installed when XigmaNAS is booted.  Before adding an additional Ethernet Interface to XigmaNAS, ensure that the additional interfaces are installed when XigmaNAS is booted. 
  
-To add an additional interface, go to the Interfaces (assign) page. If your additional Ethernet interface is recognised, you will have a {{:wiki:documentation_setup_and_user_guide_basic.add.gif|}}  alongside the standard display, as shown below. If you do not have a {{:wiki:documentation_setup_and_user_guide_basic.add.gif|}} on this display, your interface is either not correctly installed or not recognised by NAS4Free.+To add an additional interface, go to the Interfaces (assign) page. If your additional Ethernet interface is recognised, you will have a {{:wiki:documentation_setup_and_user_guide_basic.add.gif|}}  alongside the standard display, as shown below. If you do not have a {{:wiki:documentation_setup_and_user_guide_basic.add.gif|}} on this display, your interface is either not correctly installed or not recognised by XigmaNAS.
  
 {{:wiki:documentation_setup_and_user_guide_net.lan.add.png|}} {{:wiki:documentation_setup_and_user_guide_net.lan.add.png|}}
Line 41: Line 41:
 OPT1 is the default name of the interface, and this can be customized. Once OPT1 is configured you will notice an additional level under Interfaces (assign) called OPT1. OPT1 is the default name of the interface, and this can be customized. Once OPT1 is configured you will notice an additional level under Interfaces (assign) called OPT1.
  
-Click Save and reboot XigmaNAS to ensure the additional interface is recognised. You can reboot NAS4Free via the Diagnostics/Reboot System page.+Click Save and reboot XigmaNAS to ensure the additional interface is recognised. You can reboot XigmaNAS via the Diagnostics/Reboot System page.
  
 Once XigmaNAS is again operational, you can configure the OPT1 interface and rename it to something more relevant to your network. Once XigmaNAS is again operational, you can configure the OPT1 interface and rename it to something more relevant to your network.
documentation/setup_and_user_guide/network_interface_lan.1538340749.txt.bz2 ยท Last modified: 2018/09/30 22:52 by zoon01